pira 5w txer LCD connection

[radium98]

i dunno what is the problem i need wire to wire connection in invastigate pleaaaaaaaase. see my pictures

[Jan]

I have no idea what else you need. The wiring has been already published in this thread. There are pin numbers 1 to 16 on the transmitter's connector and pin numbers 1 to 16 on the LCD connector. Everything you need to do is to connect 1 to 1, then 2 to 2 etc. What I see on your last photo is something far away from the working connection.

[radium98]

please jan if you can take me a close pictures for the lcd of the transmitter you have made so i can see the connection clearly .thanks btw how i will connect pin to pin when i can see 4-5 pins to ground and i must connect them on lcd where is no ground

[Jan]

Ok, so here's the connection:

1 - 1
2 - 2
3 - 3
4 - 4
5 - 5
6 - 6
7 - 7
8 - 8
9 - 9
10 - 10
11 - 11
12 - 12
13 - 13
14 - 14
15 - 15
16 - 16

16 wires total.

[radium98]

heheheh Thanks JAN i am sorry .i get new wires and i will recheck all sorry for disturbing you man .Great help

[radium98]

  Jan rewiring again with new good connection i can see the frequency on lcd with pira.cz.
Bad news i have VCO but not locking on any frequency i will rewound L1 i think it must be 4 wounds and not 3 i use single side pcb i will let you the results thanks.

[radium98]

https://www.youtube.com/watch?v=ifyUJ71V3Z4&feature=youtu.be

thanks have some little modifications after

[radium98]

Hello again what do i need as a simple software to put my name at startup i want to try that please help me

[radium98]

any help ?

[radium98]

https://www.youtube.com/watch?v=lu7aWDGs1IQ&feature=youtu.be

help me pleaseeeee to put reve fm REVE FM at start up power up tx