Posted by: jasperwilde09
« on: Today at 04:41:49 am »yes, it is very likely that they will not be able to work due to being out of coverage area free enneagram test
News:
Thank you for using this forum as the technical support base for your device.
● You can format the text and attach screenshots, photos and RDS Spy records
● Faster reply: 50 % of questions are answered within 30 minutes
● You don't need to register (but registration is possible)
● The members represent a wide range of experts
● The resolution will be helpful for other users
● You'll be notified by email about new post
Posted by: Ken
« on: November 26, 2015, 09:54:04 am »Hello again,
50khz stepping works fine for manual tuning, but I don't seem to work in Bandscan
/Ken
50khz stepping works fine for manual tuning, but I don't seem to work in Bandscan
/Ken
Posted by: Ken
« on: May 20, 2015, 02:49:47 pm »Thanks Jan, just the info I needed!
/Ken
/Ken
Posted by: Jan
« on: May 20, 2015, 11:43:42 am »Your example applies to 50 kHz step. So did you mean 50 kHz step? It can be enabled in the FM Scope.
For the software:
Options - Preferences - General: Enable 50 kHz tuning step
For the equipment:
Options - DIP switches - Tuning step
25 kHz step is not supported by the hardware. Due to IF bandwidth you may tune to the nearest frequency possible, without considerably worse results.
For the software:
Options - Preferences - General: Enable 50 kHz tuning step
For the equipment:
Options - DIP switches - Tuning step
25 kHz step is not supported by the hardware. Due to IF bandwidth you may tune to the nearest frequency possible, without considerably worse results.
Posted by: Ken
« on: May 20, 2015, 07:28:21 am »Hi,
How do I tune to a .25 frequency, like 92.25. I'm in Thailand helping a friend.
Best Regards
Ken
How do I tune to a .25 frequency, like 92.25. I'm in Thailand helping a friend.
Best Regards
Ken