Post reply

Message icon:

Unregistered users must pass a verification:

Please enter the number from the picture above which is showing FM broadcast antenna:

shortcuts: hit alt+s to submit/post or alt+p to preview

Topic Summary

Posted by: jasperwilde09
« on: April 19, 2024, 04:41:49 am »

yes, it is very likely that they will not be able to work due to being out of coverage area free enneagram test
Posted by: Ken
« on: November 26, 2015, 09:54:04 am »

Hello again,

50khz stepping works fine for manual tuning, but I don't seem to work in Bandscan


Posted by: Ken
« on: May 20, 2015, 02:49:47 pm »

Thanks Jan, just the info I needed!

Posted by: Jan
« on: May 20, 2015, 11:43:42 am »

Your example applies to 50 kHz step. So did you mean 50 kHz step? It can be enabled in the FM Scope.

For the software:
Options - Preferences - General: Enable 50 kHz tuning step

For the equipment:
Options - DIP switches - Tuning step

25 kHz step is not supported by the hardware. Due to IF bandwidth you may tune to the nearest frequency possible, without considerably worse results.
Posted by: Ken
« on: May 20, 2015, 07:28:21 am »


How do I tune to a .25 frequency, like 92.25.  I'm in Thailand helping a friend.

Best Regards