Posted by: yoyo
« on: May 23, 2012, 10:13:41 pm »Thanks for the info!
News:
Thank you for using this forum as the technical support base for your device.
● You can format the text and attach screenshots, photos and RDS Spy records
● Faster reply: 50 % of questions are answered within 30 minutes
● You don't need to register (but registration is possible)
● The members represent a wide range of experts
● The resolution will be helpful to other users
● You'll be notified by email about new post
Posted by: Jan
« on: May 23, 2012, 07:36:29 pm »Precise way is following:
1) Disable actual RT by sending RTEN byte (bit 0 set to 0).
2) Write new RT in the RT address space
3) Enable the RT by sending RTEN byte (bit 0 set to 1 and A/B flag bit toggled).
Note that some receivers may ignore the A/B flag or use this flag different way than the RDS standard specifies.
1) Disable actual RT by sending RTEN byte (bit 0 set to 0).
2) Write new RT in the RT address space
3) Enable the RT by sending RTEN byte (bit 0 set to 1 and A/B flag bit toggled).
Note that some receivers may ignore the A/B flag or use this flag different way than the RDS standard specifies.
Posted by: yoyo
« on: May 23, 2012, 07:27:41 pm »I'm looking for a little clarification on the proper use the RT A/B flag in the MRDS192...
From what I've read, it's a good idea to toggle the A/B flag any time the RT is changed.
I've tried changing it via RTEN right before sending a new message, and right after. But either way, the radios I've tested with will still sometimes garble the message for a bit immediately following a change.
What's the best way to use the flag or change RT in general?
From what I've read, it's a good idea to toggle the A/B flag any time the RT is changed.
I've tried changing it via RTEN right before sending a new message, and right after. But either way, the radios I've tested with will still sometimes garble the message for a bit immediately following a change.
What's the best way to use the flag or change RT in general?