Posted by: DASp132user
« on: July 21, 2023, 07:05:45 am »Many thanks, Jan!
I'll check the LED connection(s)....maybe a bad solder joint.....
I'll check the LED connection(s)....maybe a bad solder joint.....
News:
Thank you for using this forum as the technical support base for your device.
● You can format the text and attach screenshots, photos and RDS Spy records
● Faster reply: 50 % of questions are answered within 30 minutes
● You don't need to register (but registration is possible)
● The members represent a wide range of experts
● The resolution will be helpful to other users
● You'll be notified by email about new post
Posted by: Jan
« on: July 20, 2023, 08:00:45 pm »There's no reason for being distraught. The pilot status can be read on the LCD and it is accessible remotely as well. If the LED does not indicate the pilot anyway, the LED is probably gone or the LED cable is not connected well. You may check this by connecting power. The self-test always turns on the LED on power-up for a few seconds.
Posted by: DASp132user
« on: July 20, 2023, 07:27:25 pm »My P132 does NOT display the PILOT LED.....yet the diagnostic says PILOT is ON.
The TROUBLESHOOTING page of the manual mentions a CLOCK SOURCE setting...
It says it's in the "System sheet"....
FYI.....I don't have this unit connected via Ethernet -- just USB port for setup.
All other parameters check out OK....this is really frustrating....
I'm sure it's a simple solution --- but I can't find it!!
Any help is GREATLY appreciated!
Thanks!!
Dale Sanborn
The TROUBLESHOOTING page of the manual mentions a CLOCK SOURCE setting...
It says it's in the "System sheet"....
FYI.....I don't have this unit connected via Ethernet -- just USB port for setup.
All other parameters check out OK....this is really frustrating....
I'm sure it's a simple solution --- but I can't find it!!
Any help is GREATLY appreciated!
Thanks!!
Dale Sanborn