Old Forum

Silence Detector - Problem - Always returns to Alarm not active!

Paul, 13.11.2010, 00:08, 81.149.116.144
Problem - Always returns to Alarm not active!

Hi,

The silence detector looks a great piece of software and will do exactly what we need for our community radio station.

We have a problem though that once the software is run it stays on 'Silence!' mode for the time set in the 'Do not anything first XX seconds...' setting then switches back to 'Alarm not active!'?

Please can you help?

Best Regards, Paul... UK

Anonymous, 13.11.2010, 10:20
Re: Problem - Always returns to Alarm not active!

I haven't noticed this. If I run the application and a silence occurs, it will stay in the Silence status for unlimited time until the audio is present again.

Paul, 13.11.2010, 21:44, 86.171.3.214
Re: Re: Problem - Always returns to Alarm not active!

Hi,

The issue is the monitor does not stay on whatever parameter I change and whether there is audio present or not?

Perhaps I should re-download / re-install?

Regards, Paul...

Jan, 14.11.2010, 19:23
Re: Re: Re: Problem - Always returns to Alarm not active!

Dear Sir, I don't know about this failure. Please send the ini file and the instructions how to invoke the problem to my email address. Without these steps I'm unable to do anything.

Paul, 17.11.2010, 21:34, 86.171.3.214
Re: Problem - Always returns to Alarm not active!

Hi Jan,

We have a problem that once the software is run it stays on 'Silence!' mode for the time set in the 'Do not anything first XX seconds...' setting for the XX time and then switches back to 'Alarm not active!'?

It seems to not like staying 'Alarm Active!'. I have tried downloadinga again, re-installing it and all different settings but it will not stay on 'Alarm Active!'?

I have also tried rebooting the PC after re-configuring.

I will try and get into the station tomorrow and send the .ini file.

Thanks for your help.

Best Regards, Paul...

Back to Old Forum Mainpage