|
Remote COM Port - connect setting in the ini file
|
Back to Old Forum Mainpage
Ron, 4.10.2007, 10:06
connect setting in the ini file
I have a similar problem with version 1.3a. All the settings except 'connect' are correctly saved in the ini file. But the 'connect' setting allways changes to '0'. So the application does not get into run mode automatically. If I manually change it to '1', the application automatically gets into run mode. But on exit it turns back to '0' again whereas the last state before exit is run not stop.
Jan, 4.10.2007, 10:19
Re: connect setting in the ini file
It's fixed. Thanks.
Back to Old Forum Mainpage