Radio Data System (RDS) > MRDS1322
no quarz oscillator on MRDS1322
(1/1)
Gianni Picconi:
Good evening I have a problem,
I bought 4 pieces of the MRDS1322 but on pins 2 and 3 I do not have the frequency of oscillation
thanks in advance for your cooperation
Gianni
Jan:
Only high input impedance counter can be connected to these pins. Thus I would recommend to measure on pin 5 rather. There should be 57 kHz @ 5 Vpp.
Please post your schematic diagram or better a photo of the board.
gianni picconi:
good morning https://drive.google.com/file/d/1M1LroHVE7XrlJFakAmbWPRy3TuKW86Hb/view?usp=sharing
https://drive.google.com/file/d/1LqQgQ25AyuToET08jSXUd0E8beDzB64M/view?usp=sharing
can you verify thanks?
Gianni
Jan:
The C1 and C2 must be placed.
The XTAL pins may be short-circuited by the XTAL case - place the XTAL a few mm above the board or use an insulation pad.
Minimum configuration for getting the oscillator working is:
Pin 1: +5V
Pin 2: XTAL + 22 pF capacitor to GND
Pin 3: XTAL + 22 pF capacitor to GND
Pin 4: +5V via a resistor
Pin 20: GND
Navigation
[0] Message Index
Go to full version