General Category (This section is not monitored) > FM Transmitters, RF Amplifiers
TSA5514, AS (pin 10) control pin voltage for Master Address Select
(1/1)
Harm2k17:
It has to do with the "AS" pin (nr. 10), the applied voltage on this pin determines the address selection for the master I2C- bus.
(See Philips datasheet TSA5514, table 4).
It's about the MA0 and MA1 bits (Master Address Select).
Question; what to apply now in such a manner that the commands from the 16F627A controller are accepted by the TSA5514?
I'am really a n00b here... :-((
The applied voltage can vary between 0 (GND) and 1 (VCC, 5V).
(table 4)
MA1 MA0 VOLTAGE APPLIED ON PIN AS
0 0 0 to 0.1 Vcc
0 1 open
1 0 0.4 to 0.6 Vcc
1 1 0.9 Vcc to Vcc
Can you give me a hint?
Kind regards,
Harm
Jan:
Leave the pin "open", i.e. not connected.
Harm2k17:
--- Quote from: Jan on September 10, 2017, 07:28:22 pm ---Leave the pin "open", i.e. not connected.
--- End quote ---
Indeed! Thank you Jan, this is something i can work with. I had this port connected to gnd.
Navigation
[0] Message Index
Go to full version