FM Analysis > P175 FM Analyzer

25kHz steps

(1/1)

Ken:
Hi,

How do I tune to a .25 frequency, like 92.25.  I'm in Thailand helping a friend.

Best Regards
Ken

Jan:
Your example applies to 50 kHz step. So did you mean 50 kHz step? It can be enabled in the FM Scope.

For the software:
Options - Preferences - General: Enable 50 kHz tuning step

For the equipment:
Options - DIP switches - Tuning step

25 kHz step is not supported by the hardware. Due to IF bandwidth you may tune to the nearest frequency possible, without considerably worse results.

Ken:
Thanks Jan, just the info I needed!

/Ken

Ken:
Hello again,

50khz stepping works fine for manual tuning, but I don't seem to work in Bandscan

/Ken

Navigation

[0] Message Index

Reply