Pira.cz Technical Forum

Radio Data System (RDS) => PIRA32 RDS Encoder => Topic started by: Dimitris on May 24, 2012, 09:22:26 am

Title: What !Ready means?
Post by: Dimitris on May 24, 2012, 09:22:26 am
Hello Jan

The MagicRDS control software shows !Ready when sending commands to RDS encoder.

What does it mean ?
Title: Re: What !Ready means?
Post by: Jan on May 24, 2012, 11:51:21 am
There was a command the RDS encoder didn't understand. This typically occurs when using actual control software version but the firmware inside the encoder is old (not updated yet). This is not a critical error.