Post reply

Name:
Email:
Subject:
Message icon:
Verification:
Unregistered users must pass a verification:



Please enter the number from the picture above which is showing FM broadcast antenna:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Erics
« on: April 02, 2024, 10:16:48 pm »

I am looking at this software to use with the internal RDS encoder in the Nautel VS2.5.  Have you had any success with the NVLT yet?


Quote from: kkidd on October 27, 2022, 03:43:20 am
Thanks Jan,

I have been experimenting and it does work with ASCII Lite and UECP but I haven't figured it out enough to be confident yet.

Thanks,
Posted by: wsof
« on: December 15, 2022, 04:06:33 pm »

Hi!
We have two Nautel transmitters in use. One is a GV15 and the other is a VS1. While I use a different software for the GV15, I just started using Magic RDS with the VS1. I can say that so far the best setup that seems to work for me is the ASCII over Serial setting in the transmitter. I tried it over IP and set Magic as a TCP client but it kept disconnecting from the transmitter but once I switched to the serial connection it has worked perfect. Our setup is in a remote site so I am sending the data via a bridge to the site, writing it to a local file and then sending it to the transmitter via serial connection. The RDS encoder type that I have set in Magic is Lite ASCII. Hope this helps!

Steve
Posted by: kkidd
« on: October 27, 2022, 03:43:20 am »

Thanks Jan,

I have been experimenting and it does work with ASCII Lite and UECP but I haven't figured it out enough to be confident yet.

Thanks,
Posted by: Jan
« on: October 18, 2022, 04:28:45 pm »

I'm sure you can get it working at least for the Radiotext and Dynamic PS. There's some proprietary encoder in the Nautel which should support a limited set of ASCII and UECP but published information does not describe it well. You may try Generic UECP, Lite ASCII as well as User Defined, depending on which performs better. You don't need the Full version to try that.
Posted by: kkidd
« on: October 18, 2022, 03:33:41 pm »

Hello all,

I searched the forums and didn't find any references to using Magic4 to do RDS on a Nautel NVLT TX.  Is anyone using this combination and have tips?  I have it operating a 332 encoder but this client is about to add a new NVLT and would like to add it as well.

I am about to purchase the full version for this customer and want to make sure that it works before proceeding. 

Regards,