Posted by: nmiller0113
« on: October 30, 2017, 08:42:58 am »Thank you!
News:
Thank you for using this forum as the technical support base for your device.
● You can format the text and attach screenshots, photos and RDS Spy records
● Faster reply: 50 % of questions are answered within 30 minutes
● You don't need to register (but registration is possible)
● The members represent a wide range of experts
● The resolution will be helpful for other users
● You'll be notified by email about new post
Posted by: Jan
« on: October 30, 2017, 08:39:55 am »The MRDS192 has been designed for onboard communication (with mcu). It supports I2C protocol only so any attempt to communicate using RS-232 will fail. The TinyRDS software emulates I2C bus on pins 4 and 7.
See more information at http://pira.cz/rds/show.asp?art=support_for_older_rds_encoder_models (MiniRDS Encoder).
See more information at http://pira.cz/rds/show.asp?art=support_for_older_rds_encoder_models (MiniRDS Encoder).
Posted by: nmiller0113
« on: October 29, 2017, 07:50:04 am »Thank you for the quick response. If I wanted to write my own program in C to do this and control it over a usb to serial port, are there any documents or suggestions you may have for guidance? I noticed from monitoring the serial port on my computer when tinyrds sends signals to the MRDS192 it appears to be encoded as it can't interpret anything but the setup. Maybe I'm just not looking in the right place. Thank you again!
Posted by: Jan
« on: October 29, 2017, 07:36:26 am »There's no such software from us.
Posted by: nmiller0113
« on: October 29, 2017, 01:04:49 am »I'm trying to figure out if there is a way to control MRDS192 via software that will run on a Mac computer? I've been running it via tinyrds up until now but I'd like to switch over to a Mac and was wondering if that was even possible because all the software I've seen has been Windows based. Thanks!