Post reply

Warning - while you were reading 2 new replies have been posted. You may wish to review your post.
Name:
Email:
Subject:
Message icon:
Verification:
Unregistered users must pass a verification:



Please enter the number from the picture above which is showing FM broadcast antenna:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: jejilo2796
« on: September 19, 2025, 04:44:21 pm »

Živjo, moram priznati, da sem bil do športnih stav vedno malce skeptičen. Ampak kolega iz šihta mi je en dan poslal link do https://stavesportne.com/ in rekel: »Probaj, saj nimaš kaj izgubiti.« Bral sem nekaj člankov, ki so bili napisani kar direktno, brez olepševanja, in to mi je pasalo. Najbolj zabavno je bilo, ko sem v živo spremljal nogomet in zraven gledal priporočila – počutil sem se, kot da se z nekom prepiram v gostilni, samo da ni bilo piva. Tudi, ko sem falil stavo, sem imel občutek, da je bilo vseeno vredno, ker sem se nasmejal do solz ob nekaterih komentarjih.
Posted by: Rafael Reali
« on: December 04, 2022, 05:06:02 pm »

If you are testing the circuit on a PLL transmitter, it needs to have good damping (or delay) on the correction signal, otherwise it will combat the pilot signal from the stereo generator.

  I suggest testing the stereo circuit on a free oscillator.
Posted by: max-bit
« on: January 21, 2021, 08:08:28 pm »

Hi
I built a stereo encoder based on this project
https://pira.cz/eng/stk2en.htm
However, I have a problem with channel separation, it doesn't want to be better than the 35dB channel separation. This is not a problem of the receiver as it has a separation of ~ 43 dB (measured on a professional generator). What could be the problem?

I am attaching the eagle drawing.

thanks in advance for your comments and help
Posted by: radium98
« on: January 13, 2016, 08:53:47 pm »

Still cant burn the hex into the pic i think the 2 pics are fakes one be aware.
Posted by: radium98
« on: January 10, 2016, 02:29:39 pm »

 :D hi i am going to make the stereo encoder and here is some pictures of the project thanks to Jan.Having 1 question i did not find the U7 - PIC18F1220-I/P  i tried to use PIC18F1320-I/P as it seems must work under the data sheet and its a bit pricy does it work or no ?
thanks