Radio Data System (RDS) > P132, P164, P232(U) and P332 RDS Encoders

P132 Internal vs External clock setting

(1/1)

DASp132user:
My P132 does NOT display the PILOT LED.....yet the diagnostic says PILOT is ON.
The TROUBLESHOOTING page of the manual mentions a CLOCK SOURCE setting...
It says it's in the "System sheet"....???
FYI.....I don't have this unit connected via Ethernet -- just USB port for setup.
All other parameters check out OK....this is really frustrating....
I'm sure it's a simple solution --- but I can't find it!!
Any help is GREATLY appreciated!
Thanks!!

Dale Sanborn

Jan:
There's no reason for being distraught. The pilot status can be read on the LCD and it is accessible remotely as well. If the LED does not indicate the pilot anyway, the LED is probably gone or the LED cable is not connected well. You may check this by connecting power. The self-test always turns on the LED on power-up for a few seconds.

DASp132user:
Many thanks, Jan!
I'll check the LED connection(s)....maybe a bad solder joint.....

Navigation

[0] Message Index

Reply