|
Radio Data System - phase difference after firmware upgrade
|
Back to Old Forum Mainpage
Kreso, 21.4.2010, 13:50, 93.139.76.1
phase difference after firmware upgrade
I have upgradded Pira rds firmware to version 1.5a and after that i get rds signal with phase difference of 79 degrees (measured with Pira analyser).Before upgrde there's no phase diffrence. How can i correct phase with commands. And another problem, new version of Magic rds software is crashing on my pc, maybe it's only on my pc. I use Jazler and i try to switch On Ta commands automatcaly with traffic jingle.
admin, 21.4.2010, 15:38
Re: phase difference after firmware upgrade
RDS phase can be corrected by command PHASE. Pdf manual page 9 and 31, help section System. Maybe it would be useful to look there.
Any software related suggestions must be forwarded to Jan's email as mentioned in the application help, including all configuration data. Nobody can help you here. The problem will be eliminated immediately.
Back to Old Forum Mainpage